Code Alarm CA680 Manual de usuario descargar pdf (Pagina 12)

3. DOOR LOCKS

Negative Unlock Output (GREEN)

Negative Lock Output (BLUE)

Negative Second Door Unlock Output (TAN)

Positive Switching and Positive Switching with 2-step unlock feature:

All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch.

Verification: These wires will register positive voltage when the Lock and Unlock switches are activated.

Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside the driver’s door.

Verification: This wire will rest at ground and register positive voltage when the driver’s door is unlocked.

Connect the GREEN and BLUE or TAN wires shown in diagram 8 below.

Note: When adding the 2 step unlock feature the TAN 2nd door unlock wire will be used to unlock all vehicle

doors on the second press of unlock. This feature must be turned on in programming. Three additional

SPDT relays (not supplied) are required. Connect the relays as shown in diagram 9 below to unlock the

driver’s door on the first press of unlock.

Diagram 9

Lock

Unlock

Door Lock Switch

Vehicle Door Lock

Control Relays

87a

GR E E N (-) or TAN (-)

2nd Door Unlock Output

Fused +12 Volt

Battery Source

Diagram 8

GREEN (-) Unlock Output

87a

To Unlock Side Of

Driver's Door Actuator

Fused +12 Volt

Battery Source

From Keyless E ntry

Module Or Door

Lock/Unlock Relays

CUT

87a

BLUE (-) Door

lock O utput

Fused +12 Volt

Battery Source

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Sin comentarios

Code Alarm CA680 Manual de usuario Pagina 12