Code-alarm CA-310 Manual de usuario descargar pdf

128-6832

1 of 16

Avoid mounting components or

routing wires near hot surfaces

Avoid mounting components or

routing wires near moving parts

Tape or loom wires under hood

for protection and appearance

Use grommets when routing wires

through metal surfaces

Use a voltmeter for testing and

verifying circuits

PROFESSIONAL INSTALLATION

STRONGLY RECOMMENDED

Installation Precautions:

Roll down window to avoid locking

keys in vehicle during installation

FCC COMPLIANCE

This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including any interference that may cause undesired operation.

Warning!

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Technical Support

For Authorized Dealers (800) 421-3209

CA-310 Installation Instructions

Kit Contents

(1) - Control Module

(2) - 2 Button High Frequency Transmitters

(1) - Multi Pin Input/Output Harness

(1) -2 Pin Door Lock Harness

(1) - IRS-Shock Sensor

(1) - Programming Switch

(1) - Literature Package

(1) - Siren

1 2 3 4 5 6 7

128-6832 1

Indice de contenidos

Pagina 1 - 128-6832

128-68321 of 16Avoid mounting components orrouting wires near hot surfacesAvoid mounting components orrouting wires near moving partsTape or loom wire

Pagina 2

128-68322 of 162INSTALLATION OF THE MAJOR COMPONENTSControl Module:Select a mounting location inside the passenger compartment (behind the dash), and

Pagina 3

128-68323 of 163WIRING THE SYSTEMRed: +12 VDC CONSTANT BATTERY SOURCEConnect this wire to a +12 Volt constant source found at the vehicles ignition s

Pagina 4

128-68324 of 164Grey: (-) Hood/Trunk TriggerThis is an instant on ground trigger wire. It must be connected to the previously installed hood and/ortru

Pagina 5

128-68325 of 16Black/White: Illuminated Entry Output 200 mA (-)This wire provides a 30 second ground output whenever the system is disarmed using the

Pagina 6

128-68326 of 165COMPLETING THE INSTALLATIONAdjusting the Shock Sensor: Gently turn the adjustment knob counterclockwise to turn down the sensitivityan

Pagina 7

128-68327 of 165BLACK/RED1 - 8SELECTABLE PULSED OUTPUT(-)WHITE/BLUE (ARM INPUT)