Code Alarm CA680 Manual de usuario descargar pdf (Pagina 12)

Hood Pin Input (GRAY)

Install a Hood Pin Switch and connect to the GRAY wire. This connection is required for Remote Start.

Verification: This wire when connected will register ground when the vehicle's hood is opened.

Connect the GRAY wire to the hood pin.

Note: Be sure to loom the wire, and seal the grommet.

Low Current Horn Output (BROWN/BLACK)

Locate the vehicle’s horn wire at the steering column.

Verification: This wire will register at positive voltage and register ground when the horn switch is pressed.

Connect the BROWN/BLACK wire to the vehicle’s horn wire.

Instant Trigger Input (BLUE/WHITE)

This wire is a GROUND input for an external sensor or secondary pin switch.

Verification: This wire when connected will trigger the security system

Siren Output (+) (BROWN)

Locate a suitable mounting location in the engine compartment for the siren, away from moving parts.

With the bell of the siren aiming downwards, secure the siren in place using self tapping screws, being

careful not do drill into any hoses, wiring or components.

Connect the BLACK siren wire to a chassis ground using a ring terminal and self tapping screw (not

supplied).

Route the BROWN siren output wire from the control module through the firewall and connect to the RED

wire on the siren.

Note: Be sure to loom the siren wires, and seal the grommet.

2. 22 PIN BASE HARNESS CONTINUED

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Sin comentarios

Code Alarm CA680 Manual de usuario Pagina 12