Code Alarm F65 Manual de instrucciones descargar pdf (Pagina 19)

Attaching a Lens

Chapter 2 Installation and Preparations

To change a shim

Exercise care not to damage the internal wiring of the

camera when changing the shim. Modifying a shim,

scratching a surface, or introducing dust can change the

flange back distance and damage the camera such that it

cannot be restored to original condition, just as for a film

camera.

Remove the lens mount screws (6).

Pull the lens mount out by about 10 mm (

inch)

and remove the shim carefully.

Pass the shim slit over the wiring, taking care not to

pull the wiring, when removing the shim.

Pulling the lens mount out by more than 20 mm

(

inch) risks damage to the internal wiring.

Insert the replacement shim using the shim slit to clear

the wiring, and align the camera screw holes and shim

alignment pins.

Reattach the lens mount in its original position, and

fasten the screws to a torque of 0.53 N·m (0.39 lbf).

Note

Lens mount screws

Shim alignment pins

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 97 98

Sin comentarios

Code Alarm F65 Manual de instrucciones Pagina 19