Error Code 25 - Open centre position not reached, Valve internal fault, possibly
mechanical
Error Code 26 - Manual operation detected, Valve has been operated manually
Error Code 31 - Under 8 volts, Displated only if the valve does not shut-down
automatically. Valve will shut off the output stage.
Error Code 32 - Over 36 or 45 volts, Displayed only if the valve does not shut-down
automatically. Valve wil shut off the output stage.
Error Code 41 - Over 45 Volts, Valve will internally shut-down.
Error Code 42 - Output stage for the pilot solenoid valve fault, Valve internal fault.
Error Code 43 - Position transducer fault, Position of the spool detected by the
transducer.
Error Code 81 - Valve spool cannot be returned to neutral, Valve internal fault, possibly
mechanical.
Error Code 82 - Valve spool not in neutral when switched on, Valve internal fault,
possibly mechanical.
Error Code 83 - Checksum error, Self diagnostic check of the system.
Electronic Engine Codes (ECU) or PTO/Hand Throttle Codes (XCM) (both
displayed on the EIC as a lower case t)
Error Code T1 -Foot Throttle Position Sensor, Grounded Or Current Above Normal
Range
Error Code T2 -Foot Throttle Position Sensor, Open Circuit Or Current Below Normal
Range
Error Code T3 -Foot Throttle Position Sensor, Shorted To Low Source
Error Code T4 -Foot Throttle Position Sensor, Shorted To High Source
Error Code T5 -CAN AE Message (Torque Set point), Data Valid But Below Normal
Range
Error Code T6 -CAN AE Message (Torque Set point), Data Incorrect
Error Code T7 -CAN AE Message (Torque Set point), Data Valid But Above Normal
Range
Error Code T8 -Ambient Pressure Sensor, Grounded Or Current Above Normal Range
Error Code T9 -Ambient Pressure Sensor, Open Circuit Or Current Below Normal Range
Error Code T13 - Test Shut Off Paths, Data Valid But Above Normal Range
Error Code T14 - Test Shut Off Paths, Shorted To High Source
Error Code T15 - Shut-Off Signal, Data Valid But Above Normal Range
Error Code T16 - Shut-Off Signal, Shorted To High Source
Error Code T17 - PCU Power Supply, Data Valid But Above Normal Range
Error Code T18 - PCU Power Supply, Shorted To High Source
Error Code T19 -Fuel Quantity Shut-Off, Data Valid But Above Normal Range
Error Code T1A -Fuel Quantity Shut-Off, Shorted To High Source
Error Code T1B - Voltage Monitoring, Data Valid But Below Normal Range
Error Code T1C - Voltage Monitoring, Data Incorrect
Error Code T1D - Voltage Monitoring, Data Valid But Above Normal Range
Error Code T1E - Monitoring Module, Data Valid But Above Normal Range
Error Code T1F - Monitoring Module, Shorted To High Source
(65 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales