Error Code 4 - Fan speed out of range.
Error Code 5 - Maximum fan speed low (maximum fan speed demanded but not
achieved).
Error Code 6 - +5V reference error.
Error Code 7 - Fan speed output signal error.
Semi Powershift MXM/TM120-MXM/TM155
Calibration Codes (all controllers)
Error Code CF - Calibration Procedure Completed Successfully
Error Code CH - Oil Temperature Above 105 Degrees Centigrade
Error Code CL - Oil Temperature Between 10 and 19 Degrees Centigrade
Error Code U01 - Front Axle Potentiometer Open Circuit
Error Code U02 -Front Axle Potentiometer Threshold Is Higher Than The Set Limit
Error Code U03 -Front Axle Potentiometer Short Circuit Auto Calibration Procedure
Will Not Work
Error Code U04 -Front Axle Potentiometer Threshold Is Lower Than The Set Limit
Error Code U05 -Front Suspension Is Not Reaching Minimum And Maximum Position
During The Auto Calibration Procedure
Error Code U07 -Suspension Is Stationary During The Raise Command In The Auto
Calibration Procedure
Error Code U08 -Suspension Is Unable To Reach Maximum Height Within 20 Seconds
Error Code U09 -Suspension Is Stationary During The Lowering Command In The Auto
Calibration Procedure
Error Code U10 -Suspension Is Unable To Reach The Minimum Height Within 25
Seconds
Error Code U11 - Unable To Calibrate The Suspension
Error Code U12 -Auto Calibration Procedure Stopped/Vehicle Not Stationary
Error Code U19 - Oil Temperature Below 10 Degrees Centigrade
Error Code U21 - Engine RPM Too Low
Error Code U22 - Engine RPM Too High
Error Code U23 - Shuttle Lever In Neutral
Error Code U26 - Clutch Pedal Not Released
Error Code U31 - Output Speed Sensed - Tractor Moving
Error Code U33 - Hand Brake Not Applied
Error Code U34 - Seat Switch Not Activated
Error Code U36 - Maximum Allowed Clutch Calibration Value Exceeded
Error Code U37 - Engine RPM Dropped Too Soon
Error Code U38 -
High / Low synchroniser calibration values out of tolerance (Forward)
Error Code U81 - No Medium/Reverse Range Synchronizer Movement Sensed
Error Code U82 - No Low/High Range Synchronizer Movement Sensed
Error Code U83 - Synchronizer Potentiometer Connectors Swapped
Error Code U84 - Reverse And High Range Synchronizer Solenoid Connectors Swapped
Error Code U85 - Medium And Low Range Synchronizer Solenoid Connectors Swapped
Error Code U86 - Medium/Reverse Range Synchronizer Neutral Error
Error Code U87 - Low/High Range Synchronizer Neutral Error
Error Code U88 - Medium/Reverse Range Synchronizer Calibration Values Out Of
Tolerance
(65 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales